Change Your IP By Windows Command

Sometimes we need to change IP address. Following steps can help you change IP address less than one minute.

Procedure:

• Click on "Start" button
• Click on "Run"
• Type "command" and press "Enter"

Now you should at an MSDOS be prompted screen.

• Type "ipconfig/release" just like that, and press "Enter"
• Type  "exit" and leave the prompt
• Right -click on "Network Places" or "My Network places" on your desktop

You should now be on a screen with something titled "Local Area Connection", or something close to that, and if you have a network hooked up, all of your other networks.

• Right click on "Local Area Connection" and click "properties"
• Double click on the "Internet Protocol (TCP/IP) from the list under the "General " tab
• Click on "Use the following IP address"
• Create an IP address (it doesn't matter what it is.i just type 1 or 2 or 3 until I area fill up)
• Press "Tab" and it should automatically fill in the "Subnet Mask" section with default numbers.
• Hit the "OK" button here
• Hit the "OK" button again

You should now back to the "Local Area Connection" screen

• Right click back on "Local Area Connection" and  go to properties again
• Go back to the "TCP/IP" settings
• This time, select "Obtain an IP address automatically"
• Hit "OK"
• Hit "OK" again
• Now you have a new IP address

With a little practice, you can easily get this process down to 15 seconds.
N.B: This is only changes your dynamic IP address, not your ISP/IP address. if you plan on hacking a website with this trick be extremely careful, because if they try a little, they can trace it back.